Inglis Appliance Repair

There are a number of problems that could impact your Inglis dryer’s performance. You can attempt to avoid issues with regular maintenance, like cleaning your dryer and emptying your lint trap. That being said, it is sometimes difficult to avoid problems with your dryer, like:

• The dryer is not turning on
• Inglis dryer not getting warm after starting a cycle
• Dryer is not spinning after starting a cycle
• Dryer is making strange noises or is too noisy
• Inglis dryer is getting too hot during a cycle
• Dryer is vibrating too much
• Inglis dryer doesn't won't heat up or properly dry clothes

It's recommended that you check your Inglis electric supply before calling a technician. If the power supply for your oven is in order, then the problem is best determined by a professional.

When your washer gives you trouble, it can be a very frustrating experience. The idea of cleaning all your clothes manually is a non-starter for most homeowners. Modern washers are known for their many features and, as a result, some of the most common Inglises are:

• The electronic part of your appliance. In some cases it’s a small part that needs to be replaced and, in other cases, some more significant parts need changing.
• Pump problems can prevent water from entering or leaving your washer, and this could mean that you’ll need to get some buckets ready while you wait for the technician
• The motor on any washer works particularly hard during every wash cycle and wear and tear in this area can also cause parts to break
• Inglis washer is not turning on
• Washer won’t spin during a cycle
• The washer fails to drain
• Inglis washer is leaking water
• Inglis washer is vibrating
• Washer won't run or stops mid-cycle
• Washer smells bad

No matter the problem or make of your washer, Max Appliance Repair will be right over to take care of the issue.

• DC: Unbalanced Load Preventing Washer From Spinning
Pause or stop the load to redistribute the clothes so they're more balance throughout the drum. Once that's done press the cycle selector dial to continue the load.

• DL: Door is Unlocked While Washer is Running
Press the power button on the keypad then restart your cycle. If the code reappears after the reset, then there is an issue with your door lock latch and will need service.

• HR: Water Temperature Control Problem
Check the control panel for any issues with the wiring on the temperature sensor. If you see any loose or stripped wires, this may call for a replacement of either the sensor or the main board.

• ND: Washer is Not Draining Water
Unplug your washer and check the fuse or reset the circuit breaker. Also check the drain hose, eliminating any kinked or damaged hoses. Plug in the washer and reset the cycle. If the problem persists call a technician for more assistance.